Proxmark3 community
Research, development and trades concerning the powerful Proxmark3 device.
Remember; sharing is caring. Bring something back to the community.
"Learn the tools of the trade the hard way." +Fravia
You are not logged in.
Announcement
Time changes and with it the technology
Proxmark3 @ discord
Users of this forum, please be aware that information stored on this site is not private.
Pages: 1
Topic closed
#1 2021-07-19 14:01:09
- yacc143
- Contributor
- Registered: 2021-07-19
- Posts: 4
Introduction
Hi!
I'm a software developer, although I do some devops from time to time.
Out of curiousity I decided to extend my RFID knowledge, from the purely theoretical to the more practical. I managed to install my new shiny proxmark3 RDV4, upgrade the firmware, etc, but I'm currently fighting with an issue of how to identify an unknown tag (I do know that it's 125KHz probably, as the reader lights the 125kHz light on the field detector.
pm3 OTOH, when I try to run the "auto" command, just stops the LF run after the COTAG try. 
So I'd appreciate access to the forums to see if I can find any suggestions how to continue.
thanks,
yacc143
Offline
#2 2021-07-19 15:33:47
- iceman
- Administrator
- Registered: 2013-04-25
- Posts: 9,507
- Website
Re: Introduction
Welcome and thank you for reading the introduction post http://www.proxmark.org/forum/viewtopic.php?id=1125.
Your access rights has been updated.
Offline
Pages: 1
Topic closed