Proxmark3 community

Research, development and trades concerning the powerful Proxmark3 device.

Remember; sharing is caring. Bring something back to the community.


"Learn the tools of the trade the hard way." +Fravia

You are not logged in.

Announcement

Time changes and with it the technology
Proxmark3 @ discord

Users of this forum, please be aware that information stored on this site is not private.

#1 2013-08-12 15:11:46

scroggyg
Contributor
Registered: 2012-09-07
Posts: 14

USB Driver Win7 64 Bit

I have upgraded to the current bootloader using a J-Link, as all other methods didn't seem to work.
I have tried the recommendations of the posts to use gpedit.msc.
I have installed drivers whilst pressing the button. The best I can get so far is that if I connect the USB port whilst pressing the button, I get it appearing as a COM port, but when I release the button. It appears a proxmark 3 device with a yellow exclamation mark, and then re-installs as a USB devcie.
I have uninstalled the previous USB drivers.
The same applies on a WIN 7 32 bit machine, and under VMWare.
Any thoughts?

Offline

#2 2013-08-12 17:15:43

scroggyg
Contributor
Registered: 2012-09-07
Posts: 14

Re: USB Driver Win7 64 Bit

I subsequently went and brought up all USB COM drivers that had been installed on my machine, de-installed them all and it worked. It was previously appearing as COM13, now COM3 and working.
Regards

Offline

#3 2013-08-12 17:58:38

scroggyg
Contributor
Registered: 2012-09-07
Posts: 14

Re: USB Driver Win7 64 Bit

http://support.microsoft.com/kb/315539 explains how to view hidden currently unconnected devices, then disable them one by one.

Offline

Board footer

Powered by FluxBB