Proxmark3 community

Research, development and trades concerning the powerful Proxmark3 device.

Remember; sharing is caring. Bring something back to the community.


"Learn the tools of the trade the hard way." +Fravia

You are not logged in.

Announcement

Time changes and with it the technology
Proxmark3 @ discord

Users of this forum, please be aware that information stored on this site is not private.

#1 2012-09-06 18:28:00

reks13
Contributor
Registered: 2010-12-10
Posts: 16

How to use proxmark3 with hitag-2

I have proxmark versions:
#db# Prox/RFID mark3 RFID instrument
#db# bootrom: svn 486-unclean 2011-08-28 18:52:03
#db# os: svn 486-unclean 2011-08-28 18:52:03
#db# FPGA image built on 2009/12/ 8 at  8: 3:54

How i can emulate Hitag-2 cards?
I see hitag2.c in armsrc so as i understand firmware of my proxmark3 has ability for working with hitag-2?
But how to use it? I cant find any commands for hitag.

Offline

#2 2012-09-18 14:54:45

rule
Member
Registered: 2008-05-21
Posts: 417

Re: How to use proxmark3 with hitag-2

Please update to the latest SVN repository (r620+).

proxmark3> lf hitag sim hitag2.ht2

Offline

#3 2012-09-19 06:43:56

reks13
Contributor
Registered: 2010-12-10
Posts: 16

Re: How to use proxmark3 with hitag-2

Thanks, it works. Where i ould find more info about theese news commands?
When i use command "lf hitag sim", when reader changed some data in pages how i can read what data was changed ?

Offline

#4 2012-09-20 18:01:22

vivat
Contributor
Registered: 2010-10-26
Posts: 332

Re: How to use proxmark3 with hitag-2

How can I read PCF7936 chip? What antenna do I need to read car immobilizer chips? My home-made antenna doesn't react to it. Do I need to use some antenna like on this pic?
2011050714459299.jpg

Offline

#5 2012-09-20 19:58:56

rule
Member
Registered: 2008-05-21
Posts: 417

Re: How to use proxmark3 with hitag-2

After some testing I came to the conclusion that it works great if you have a smaller (focused) antenna.
What I mean is a Low Frequency (LF) antenna made from a lot of copper windings with a diameter of around 4cm.
The usb Hi-Rose cable length doesn't matter so much (in comparison to a HF antenna).

What actually worked great for me was to use the biggest (65x35mm) 125 kHz antenna from SonMicro. You need to fold the antenna once, so you will get a double circle. Welt both ends of the antenna to the RED and WHITE wire of a usb Hi-Rose cable (cut at around 25 cm length works great). This will give you a 30v antenna at 125kHz and 41v at 134kHz.

Good luck, keep us posted if you have any results from your experience wink

PS. You can always look with "proxmark3>lf hitag list" if the read worked partially (reading id alone for example).

Offline

Board footer

Powered by FluxBB