Proxmark3 community

Research, development and trades concerning the powerful Proxmark3 device.

Remember; sharing is caring. Bring something back to the community.


"Learn the tools of the trade the hard way." +Fravia

You are not logged in.

Announcement

Time changes and with it the technology
Proxmark3 @ discord

Users of this forum, please be aware that information stored on this site is not private.

#1 2020-08-27 17:29:08

Locksmith2020
Contributor
Registered: 2020-08-27
Posts: 3

Hi-Proxmark3 RDV4

Hi.

I have bought the latest proxmark complete package RDV4, with BT addon etc. I have used this link to set up the client environment and driver on my PC which is running windows 10 64x: https://github.com/Proxmark/proxmark3/wiki/Windows#requirements.

I got up to step 10 and ran the runme64 file and the terminal downloaded repos and updated without any issues, i then exited and ran again, and i now see this:

mkdir: cannot create directory '/pm3': File exists
/pm3 could not be created.
Setting HOME to /tmp.
pm3 ~$


and when i try to run step 11 i get this:

mkdir: cannot create directory '/pm3': File exists
/pm3 could not be created.
Setting HOME to /tmp.
pm3 ~$ "make clean && make all"
bash: make clean && make all: command not found
pm3 ~$ make clean && make all
make: *** No rule to make target 'clean'.  Stop.
pm3 ~$

Could i please have some help in regards to this so i can connect to my proxmark, the proxmark driver needed is already installed onto my PC.

Kind Regards.

Offline

#2 2020-08-27 18:20:10

iceman
Administrator
Registered: 2013-04-25
Posts: 9,497
Website

Re: Hi-Proxmark3 RDV4

Welcome and thank you for reading the introduction post http://www.proxmark.org/forum/viewtopic.php?id=1125.

Your access rights has been updated.



Ps.
don't spam post,  showing that you didn't care reading the rules when creating your account.

Offline

Board footer

Powered by FluxBB