Proxmark3 developers community

Research, development and trades concerning the powerful Proxmark3 device.

Remember; sharing is caring. Bring something back to the community.


"Learn the tools of the trade the hard way." +Fravia

You are not logged in.

#1 2020-06-27 09:20:09

Taha
Contributor
Registered: 2020-06-24
Posts: 11

Hello dear friends,

Its Antonio from Spain, I have a Proxmark3 and I'm getting familiar with it. I have sth in mind which I want to see the possibility of its implementation or it has already been done. I know it's an introduction, but Iceman can you help me out here. I want to eliminate the need for having a PC (OS-based platforms and requirement for a software-client) as the Proxmark's controller. I want to use an STM Microcontroller as the controller of proxmark3, sending and receiving commands over USB to Serial, but the commands as I sniffed the USB port are coded into hex values, and the response as well. I did not find any material regarding the coding of the commands and decoding of the returned data.

Offline

#2 2020-06-27 14:21:06

iceman
Administrator
Registered: 2013-04-25
Posts: 6,557
Website

Re: Hello dear friends,

Welcome and thank you for reading the introduction post http://www.proxmark.org/forum/viewtopic.php?id=1125.

Your access rights has been updated.


If you feel the love,  https://www.patreon.com/iceman1001

modhex(hkhehghthbhudcfcdchkigiehgduiehg)

Offline

Board footer

Powered by FluxBB