Proxmark3 community

Research, development and trades concerning the powerful Proxmark3 device.

Remember; sharing is caring. Bring something back to the community.


"Learn the tools of the trade the hard way." +Fravia

You are not logged in.

Announcement

Time changes and with it the technology
Proxmark3 @ discord

Users of this forum, please be aware that information stored on this site is not private.

#1 2019-07-21 09:15:46

zwt2135
Contributor
Registered: 2017-06-15
Posts: 2

[RDV4] Brute Force for Standalone

Hey guys does anyone know if there is any firmware for the RDV4 that allows you to use the brute force scripts in standalone mode? I currently have Icemans most recent firmware and I know how to utilize the lf hid brute commands. However I wanted to know if there is a way to use this in standalone mode. I am familiar with the old Proxbrute but it is quite old.

Offline

#2 2019-07-23 08:42:46

iceman
Administrator
Registered: 2013-04-25
Posts: 9,497
Website

Re: [RDV4] Brute Force for Standalone

The most common standalone modes is incorporated in to any iceman based repo.  For RRG/Iceman repo it very easy to swap standalone modes (you must compile / flash)  but they are there.  I dont take any reponsibility to how well they are working,  since I didnt write them.  They do however compile smile

Offline

Board footer

Powered by FluxBB