Proxmark3 developers community

Research, development and trades concerning the powerful Proxmark3 device.

Remember; sharing is caring. Bring something back to the community.


"Learn the tools of the trade the hard way." +Fravia

You are not logged in.

#1 2018-09-28 21:14:30

Spyder
Contributor
Registered: 2017-12-20
Posts: 21

[SOLVED] How to connect alternative LF Antenna to PM3 Easy

Hi

How does the LF Antenna on the PM3 Easy connect to the main circuit board?

I can't see any obvious connectors.

Have looked and cannot find any references.

Thanks in advance

Spyder

Last edited by Spyder (2018-10-02 18:17:43)

Offline

#2 2018-10-02 18:17:25

Spyder
Contributor
Registered: 2017-12-20
Posts: 21

Re: [SOLVED] How to connect alternative LF Antenna to PM3 Easy

PM3.jpg

£2.95 from eBay https://www.ebay.co.uk/itm/RFID-Reader- … 2749.l2649

Works perfectly.

Last edited by Spyder (2018-10-02 18:23:18)

Offline

#3 2019-02-28 13:26:35

tristanik
Contributor
Registered: 2014-11-25
Posts: 95

Re: [SOLVED] How to connect alternative LF Antenna to PM3 Easy

But in this way the two antennas work in parallel

Offline

#4 2019-07-18 11:49:27

w106
Contributor
Registered: 2019-07-18
Posts: 3

Re: [SOLVED] How to connect alternative LF Antenna to PM3 Easy

You can connect the new antenna as Spyder said then put it close to the original antenna as the picture,if you put the new antenna away from the original one, you will get a much lower voltage of the LF antenna.
Otherwise, you can remove the origenal antenna and just connect the new one to the central screws (with some arrows near it)
Sorry for my bad English

Offline

Board footer

Powered by FluxBB