Proxmark3 developers community

Research, development and trades concerning the powerful Proxmark3 device.

Remember; sharing is caring. Bring something back to the community.


"Learn the tools of the trade the hard way." +Fravia

You are not logged in.

#1 2019-07-18 04:21:08

w106
Contributor
Registered: 2019-07-18
Posts: 3

Hello!

Hello! I've bought a PM3 and I want to know these things:
1.
how to sniff the communication between a 125khz card and the reader
2.
how to deal with a ID card which does not have a typical freq.(200khz,500khz),because these special cards are common in china
3.
how does PM3 know if it's a t5577 card when the t5577 card has been configured as a em4100 card, because some reader can recognize it and give no access to it
4.
Can PM3 write data to F8262/8310 card to make it simulate the em4100 card, which is a function in most of the chinese cloner
5.
more infomation about the raw data

I hope I can get these things by searching in the forum and asking in the forum.
Thanks.

Offline

#2 2019-07-18 07:22:48

0xFFFF
Administrator
From: Vic - Australia
Registered: 2011-05-31
Posts: 625

Re: Hello!

Welcome and I suggest you read http://www.proxmark.org/forum/viewtopic.php?id=1125 as an introduction.

Your access rights has been updated.


Want to contact me? Here's my email address...
modhex(ecijhhhhhhhhfchdhbidhniihghdduhehvhtduhbig)

Offline

Board footer

Powered by FluxBB