Proxmark developers community

Research, development and trades concerning the powerful Proxmark3 device.

Remember; sharing is caring. Bring something back to the community.


"Learn the tools of the trade the hard way." +Fravia

You are not logged in.

#1 2018-07-12 21:29:37

jkk
Contributor
Registered: 2018-07-12
Posts: 2

my pm3 something wrong....

hi

I bought a proxmark3 easy yesterday. (clone model)

model pic
https://drive.google.com/file/d/1yAKYG9daL3NE2Dr9tJTrbnqI0JP2Dwj1/view

However, there was a problem during the driver install process(prox-space master)
after driver installation, Not recognized even when proxmark 3 is plugged into usb
oddly....It is recognized by pressing and holding the button on the proxmark3 and plugging it into usb.
Release the button to disconnect again.I think I need to remove the driver.
But if I release the button disconnect again I'd like to know if anyone has experienced the same problem as me.

So I join the forum to find a solution.I'd like to get a lot of help

Offline

Board footer

Powered by FluxBB