Proxmark developers community

Research, development and trades concerning the powerful Proxmark3 device.

Remember; sharing is caring. Bring something back to the community.


"Learn the tools of the trade the hard way." +Fravia

You are not logged in.

#1 2018-07-12 20:19:39

jkk
Contributor
Registered: 2018-07-12
Posts: 2

hi

hi

I bought a proxmark3 easy yesterday.
However, there was a problem during the driver install process
after driver installation, Not recognized even when proxmark 3 is plugged into usb
oddly....It is recognized by pressing and holding the button on the proxmark3 and plugging it into usb.
Release the button to disconnect again.I think I need to remove the driver.
But if I release the button disconnect again I'd like to know if anyone has experienced the same problem as me.

So I join the forum to find a solution.I'd like to get a lot of help.

Offline

#2 2018-07-12 20:44:54

iceman
Administrator
Registered: 2013-04-25
Posts: 4,880
Website

Re: hi

Welcome and I suggest you read http://www.proxmark.org/forum/viewtopic.php?id=1125 as an introduction.


冰人

modhex(hkhehghthbhudcfcdchkigiehgduiehg)

Offline

Board footer

Powered by FluxBB