Proxmark developers community

Research, development and trades concerning the powerful Proxmark3 device.

Remember; sharing is caring. Bring something back to the community.


"Learn the tools of the trade the hard way." +Fravia

You are not logged in.

#1 2018-04-17 14:40:03

Jk123
Contributor
Registered: 2018-03-12
Posts: 6

send raw data command for an entire communication

I was curious that just by using send command., can we perform below communication?

R: 26                                    => Welcome (REQA) (or use WUPA = 0x52)
T: 44  03                                => Respond (ATQA)
R: 93  20                                => Select cascade 1 (SEL)
T: 88  04  34  74  cc                    => CT, UID(byte 1,2,3), BCC
R: 93  70  88  04  34  74  cc  0e  05    => Select available tag (SEL)
T: 24  d8  36                            => Select Acknowledge (SAK)
R: 95  20                                => Select cascade 2 (SEL)   
T: e1  e3  1c  80  9e                    => UID(byte 4,5,6,7), BCC
R: 95  70  e1  e3  1c  80  9e  b9  e1    => Finish select (SEL)
T: 20  fc  70                            => SAK without cascade bit set
R: e0  50  bc  a5                        => Request Answer to Select (RATS)
T: 06  75  77  81  02  80                => ATS (DESFire EV1)
R: 50  00  57  cd                        => Disable (HALT)


Regards,
Jk123

Offline

Board footer

Powered by FluxBB