Proxmark developers community

Research, development and trades concerning the powerful Proxmark3 device.

Remember; sharing is caring. Bring something back to the community.

"Learn the tools of the trade the hard way." +Fravia

You are not logged in.

#1 2017-12-15 11:16:36

From: Greece
Registered: 2017-12-05
Posts: 4

Getting UART from the board


I'm trying to add SD Card logging support to the board. I was thinking of just sending some pre-defined commands via UART to proxmark (hf mfu sniff and then hf list 14a) from an arduino (3v3 of course). How can I access a UART port?


Board footer

Powered by FluxBB