Proxmark developers community

Research, development and trades concerning the powerful Proxmark3 device.

Remember; sharing is caring. Bring something back to the community.


"Learn the tools of the trade the hard way." +Fravia

You are not logged in.

#1 2017-09-12 16:54:07

Rfidman
Contributor
Registered: 2017-09-08
Posts: 6

Nexkey

Cloning NEXKEY

Last edited by Rfidman (2017-09-20 04:46:18)

Offline

#2 2017-09-14 06:08:13

marshmellow
Moderator
From: US
Registered: 2013-06-10
Posts: 2,091

Re: Nexkey

So I assume you figured out the nexkey.

Offline

#3 2017-09-20 04:44:25

Rfidman
Contributor
Registered: 2017-09-08
Posts: 6

Re: Nexkey

Yes, it was easy, i setup for T55xx, same Bit Rate and modulation, then i copied the first 4 blocks, and it works.
But i have another questions.

I need to change the NexWatch ID.

The first block specifies the Data Bit Rate, modulation and the blocks they transmit.

The NexWatch ID has 8 digits.

i dont have the format of the netkey.

Last edited by Rfidman (2017-09-20 06:33:21)

Offline

#4 2017-09-28 19:49:16

vrocco
Contributor
Registered: 2017-09-28
Posts: 6

Re: Nexkey

This is a card I am interested in learning more about as I have encountered some recently at a client site. I see there's not many prebuilt commands for it in the Proxmark software. I'm just at the beginning stages of learning how to get information from a card that doesn't already have a prebuilt command set.

I read the one long thread figuring out the demod. Any other resources you could point me toward?

Offline

#5 2017-09-28 20:31:14

marshmellow
Moderator
From: US
Registered: 2013-06-10
Posts: 2,091

Re: Nexkey

Check the wiki and use the command help if available

Offline

#6 2017-09-28 21:13:26

vrocco
Contributor
Registered: 2017-09-28
Posts: 6

Re: Nexkey

Thanks, that was the first thing I did along with searching for other threads here. There's just not a whole lot

Offline

Board footer

Powered by FluxBB