Proxmark3 community

Research, development and trades concerning the powerful Proxmark3 device.

Remember; sharing is caring. Bring something back to the community.


"Learn the tools of the trade the hard way." +Fravia

You are not logged in.

Announcement

Time changes and with it the technology
Proxmark3 @ discord

Users of this forum, please be aware that information stored on this site is not private.

#1 2014-12-16 08:20:56

kevinkm
Contributor
Registered: 2014-11-07
Posts: 20

A error after compiled, someone help please!

No errors occur while it was compiling, but the moment I input ./client/proxmark3.exe, it shows a warning window, it seems like ZNKst9exception4whatev error in libstdc++-6.dll, Iam pretty sure this DLL file have already exist in directory of windows/system32 and ./client, and the DLL file is totally ok.

By the way, the size of proxmark3.exe I compiled is over 4MB, normal? it's just 1MB in version 0.0.5 by asper, and 0.0.5 works very well.

FYI, It will run without errors if only input proxmark3.exe, however, input proxmark3 com or xxx(xxx can be any letter by any length), it always hints that ERROR:invalid serial port, the warning window has been showed by following 1.5 seconds, and then the program has crashed...... What a curiousity.


Where was I going wrong?

environment:

    * devkitARM r41
    * SVN 1.7.4
    * Qt 4.6.2
        * Windows7 64bit

Offline

#2 2014-12-16 09:42:30

kevinkm
Contributor
Registered: 2014-11-07
Posts: 20

Re: A error after compiled, someone help please!

I downloaded the proxmark3-master.zip today.

Offline

#3 2014-12-16 13:52:08

marshmellow
Contributor
From: US
Registered: 2013-06-10
Posts: 2,302

Re: A error after compiled, someone help please!

Duplicate post...

Offline

#4 2014-12-19 08:00:02

kevinkm
Contributor
Registered: 2014-11-07
Posts: 20

Re: A error after compiled, someone help please!

Sorry, I posted wrongly before.

Offline

Board footer

Powered by FluxBB