Proxmark3 developers community

Research, development and trades concerning the powerful Proxmark3 device.

Remember; sharing is caring. Bring something back to the community.


"Learn the tools of the trade the hard way." +Fravia

You are not logged in.

#1 2020-05-14 21:51:03

NIXIEGeek
Contributor
Registered: 2020-05-14
Posts: 2

hi - a new PM3 - RDV4 user here

look forward to learning from experts here. 

i just installed and ran the pre-compiled bits from Gater96100 - Thanks to that person - just saved my life and the agony of self-creating the bins - I am very new to this product and look forward to learning.  Thank you.

Can someone point me to a page/post/ tutorial to all the commands.  I am hoping to use PM3 for LF, HF and xDF3 (NFC).  But, first trying to learn some basic, immediately gratifying commands

thanks

Offline

#2 2020-05-14 22:01:40

iceman
Administrator
Registered: 2013-04-25
Posts: 6,553
Website

Re: hi - a new PM3 - RDV4 user here

Welcome and thank you for reading the introduction post http://www.proxmark.org/forum/viewtopic.php?id=1125.

Your access rights has been updated.


If you feel the love,  https://www.patreon.com/iceman1001

modhex(hkhehghthbhudcfcdchkigiehgduiehg)

Offline

Board footer

Powered by FluxBB