Proxmark3 developers community

Research, development and trades concerning the powerful Proxmark3 device.

Remember; sharing is caring. Bring something back to the community.

"Learn the tools of the trade the hard way." +Fravia

You are not logged in.

#1 2010-10-29 23:10:31

Registered: 2010-10-20
Posts: 2

Snooper command

Hello all, I just got my proxmark today so please bear with me.

Firmware: 20090905
Client: …

Attempting to access using Ubuntu 10.04, found the bit about running the commands as Sudo, and proceeded to try out ./snooper.

Which worked! and I am very happy... however I couldn't find any way to exit the loop... and then I had a power outage and now when I plug in the proxmark3 it enters automatically into the snooper loop. 

Please give me a direction to the docs or code where I could figure out how to bust my device out of this loop... cuz I would absolutlely hate to think that I've just turned it into a dedicated snooper.

Any help yall could offer would be great.


Board footer

Powered by FluxBB