Proxmark developers community

Research, development and trades concerning the powerful Proxmark3 device.

Remember; sharing is caring. Bring something back to the community.


"Learn the tools of the trade the hard way." +Fravia

You are not logged in.

#1 2017-03-01 15:39:24

lpv
Contributor
Registered: 2017-03-01
Posts: 4

Standalone HF emulation not working

Hi all,

I have recently updated my proxmark3 to 2.3.0 version. I connect it to an external battery and keep the proxmark button during a couple of seconds to enter in standalone mode. When both RED lights are on (proxmark is in read mode) I tap the card to the antenna and then the RED, GREEN and ORANGE lights are on so it means (as I understand) it is emulating the card.

When I approach an NFC reader the behavior is not correct. I see that the emulated card is continously sending SELECT commands and the read of the card is incorrect. Otherwise, when I am not operating in standalone mode and I load the dumped card from the terminal it works quite fine. I guess something I am not doing right to get it work in standalone mode or it thas a bug or something.

Can anyone help me on this?

Thanks in advance!

Offline

Board footer

Powered by FluxBB