Proxmark developers community

Research, development and trades concerning the powerful Proxmark3 device.

Remember; sharing is caring. Bring something back to the community.


"Learn the tools of the trade the hard way." +Fravia

You are not logged in.

#1 2016-05-16 18:54:27

Tooms
Member
Registered: 2016-04-26
Posts: 4

Will this antenna work with Proxmark3

Hi

I found this antenna but i am unsure about if it works or not..


Q1.
is it safe to connect this antenna to the PM HF or will it burn the hardware?

Q2.
Will this antenna help on the range or does the PM not have enough power to drive this?

Q3.
if the PM is having to little power to drive this antenna, is there an way to fix that.. like an amplifier or change some parts on the PM to better ones ?


As you can see i dont know much about antenna but hope you guys can help me.


specs on the antenna:
-----------------------------------------------------------------------------
dimensions: W337xH237xD8,3mm
Antenne Connection: RG58 koax-cabel, SMA-connector
Read range up to 30 cm
Operating frequency 13.56 MHz
Max. transmitting power 1.2 W
Antenna connector RG58 coaxial cable with SMA plug (50 Ω); ca. 200 mm long
-----------------------------------------------------------------------------

rfidantenna2.jpg



Thanks
Thomas

Offline

Board footer

Powered by FluxBB