Topic: Proxmark3 board build pictures
I finally got around to posting some pictures on flickr of my first board I built last week. Took me about 6 hours of hand soldering everything.
Re: Proxmark3 board build pictures
Would you be able to post the schismatics for your jtag unit
thank you
Re: Proxmark3 board build pictures
ajoakim wrote:
Would you be able to post the schismatics for your jtag unit
thank you
Read this post:
http://proxmark.org/forum/viewtopic.php?id=149
Re: Proxmark3 board build pictures
I am using this JTAG , the one in the manual is vague as to what the schematics are, if some one wants to clear it up i would be great full.
Last edited by ajoakim (2009-02-26 19:01:52)
Re: Proxmark3 board build pictures
Did you try this? It's from the manual.
Pins 3, 4 and 5 are the same.
Re: Proxmark3 board build pictures
Yeap i tried that it didn't work i guess i fried my Amtel Chip 
, but i didn't solder it for that long one pass with a 14w iron did it. Hummm how can i check to see if the chip is working, with out a scope.
Re: Proxmark3 board build pictures
n0t wrote:
Did you try this? It's from the manual.
Pins 3, 4 and 5 are the same.
http://i39.tinypic.com/2vsniae.jpg
I'd tried it but didn't work too!
Re: Proxmark3 board build pictures
Try to check your cable make sure you have the correct pins.
Pin 1 referenced below:
Parallel port 3 -> Pin 7 Prox
Parallel port 4 -> Pin 9 Prox
Parallel port 5 -> Pin 5 Prox
Parallel port 11 -> Pin 13 Prox
Parallel port 18-25 -> Pins 4,6,8,10,12,14,16,18,20 Prox
Also try a different computer or try changing the parallel port setting within your BIOS.
I got mine to work in ECP mode even thought the documentation says not to use it.
Hope this helps!
Last edited by n0t (2009-03-04 14:10:22)