Thanks, sim 2 solved.
]]>Then tried with test reader. and found it.
dump for fob, [-] no tag found, even all position changed(up-down, left-right)
hw tune result is ok. hf 26.29v with iceman newest. some legacy worked, some hs too, but this hs fob not. is this special you think?
or rdv4 is better?
Thanks again.
]]>The normal process is to do it in one go.
flasher com3 -b bootrom.elf fullimage.elf
that will solve your flashing, then afterwards the device will most likely show up on a different comport...
]]>With this condition, same result as before. how can I get success with fullimage?
Or should I send you my pm3 if do not mind?
Thanks
]]>unknown command received from reader len=4 : c 5 de 64 ff fe 5f 2 1c
unknown command received from reader len=4 : c 0 73 33 ff fe 5f 2 1c
continued... until ctrl-c
never tried reader with config fob or touched any other things. Even, with programmed fob, could not get any result with hf search...
]]>There are however a lots of countermeasures built in the readers, if sim2 fails on offical, try iceman sim2, ...
I did some video about it long time ago.
https://youtu.be/m8r5M7KWQpE
It should make things a bit clear
]]>I have rp10 reader (not r10) and pm3(official version, elechouse and easy), but could not run sim 2. Checked forum, iceman said, only with iceman version possible. correct? not with official?
With reading this forum, purpose sim 2 command is to get key from configured reader.
leaked master key is working well with blank iclass fob(legacy), but programmed fob(probably high security? not sure, in Australia), pm3 could not dump data with leaked master key because I do not know custom key. So wanted to get custom key from reader with pm3, failed.
Or should I visited that site and get custom key from that reader only? (bring pm3 and laptop?)
Any help or advice, appreciated.
]]>