force the windows device to load the correct CDC driver and check for com port changes during a flash.
Also use the latest official github code not iceman's if you don't know exactly what you are doing.
Thanks marshmellow--- it worked. Sorry for replying late. As marshmellow advised above, the solution is to force the PM3 to load the correct CDC driver.
1. clone the latest official github code (https://github.com/Proxmark/proxmark3)
2. connect the PM3, under device manager the com# port should appear
3. Flash the bootrom from the compiled official github code.
4. The PM3 will switch from com# port to the unknown device (both led's will be on)
5. Windows will start searching for the drivers of the PM3.
6. Install the drivers from the official github code repository folder
7. PM3 will appear again as com# port under device manager (unplug & plug PM3)
8. Restart the bootrom flash, it will go through
9. Repeat the same steps for flashing the fullimage (if the PM3 appears as unknown device again)
I tried this steps on a separate computer and it worked.
Thanks.
]]>@Gator, How did you manage to flash it under linux? Can you please advice?
]]>I'm using jtag as it is right now.
]]>