Just for a gag, in the second screen, JTAG speed after init, limit that to no more than 200KHz and try again.
I went ahead and set "JTAG speed after init" to 200kHz. As before, J-Flash reports success on program and verify but no observed effect on PM3.
]]>I speculate that this may be due to the flashing settings that I'm using, but I'm not sure what to change first.
Here are the current project settings I am using:
As I mentioned, these settings currently appear to "work" and J-Flash reports success, but the board's behavior does not change. All LED's are on and stay on.
Does anyone have any thoughts on what I should change to get things rolling?
]]>